The Cassini V93K Infrastructure's RIFL Hub distributes power and control to the Four RIFL top boards and two RIFL1 AUX ports (RJ45) used for controlling handler/prober and AUX Instruments via a GPIB Instrument POD. These instructions detail how to remove the access panel and replace the RIFL Hub. Contact Support ([email protected]) for specific instructions for diagnosing or replacing malfunctioning items.

There are NO electrical shock hazards from any of the exposed electrical connections on the test head or on any surface of the system. The system uses 48 volts or less and shock hazards are typically designated as to 50 volts or higher. No high-voltage cables or connections are exposed at any time during operations or when moving the system. Fixtures and Tester Instrument Modules (TIMs) can be safely removed "hot" without disconnecting power without damaging the equipment or exposing live connections to the operator.

1. IMPORTANT: Unplug the 48V DC Adapter from the Infrastructure.
2. Rotate the top of the Testhead away (as pictured). Diagram A shows the ## screw locations needed to remove the access panels for either the Testhead.
   <SPYDER HEAD DIAGRAM NEEDED>
   
3. Unscrew the Ground Cable from the mounting block. Use a flat head screwdriver to loosen the power cables. Unplug the 7 ribbon cables.
   TODO: UPDATED DIAGRAM OR PICTURES
   
4. TODO Describe each header removed.
   

1. Plug in the power cables into correct location (red to 48v and black to BLK)and secure with flat head screwdriver. Attach ground cable to the top most mount hole and reconnect all 7 flat ribbon cables The ribbon cable's header connection is keyed to provide correct orientation. Do not change the ribbon cable locations or bends in the cable.
2. Carefully re-install the side panel.
3. Connect Power to the Infrastructure.
4. Plug the TIMs back in, follow the Start Up Procedure in the Cassini V93K CTH Infrastructure Operator Information https://roos.com/docs/RBEH-DJCKZK
5. Follow the steps to run system Diagnostics.